自动化立体仓库消防给水设施设计探讨

立体仓库采用智能化出入库管理,集自动入库、智能化储存和自动化出库于一体,物品高度集中,火灾负荷集中的建筑。立体仓库的消防给水设施是其中重要的消防设施之一,本文主要分析立体仓库消防水系统的设计及参数的选择。     

基于Bootstrap方法的密封寿命可靠性评估

针对高可靠、长寿命密封件在小样本试验下的可靠性寿命评估需求,提出一种基于虚拟增广样本和Bootstrap方法的密封寿命小样本数据可靠性评估方法。并以轴用阶梯圈为例,进行寿命可靠性评估。首先通过虚拟增广法将轴用阶梯圈台架寿命试验数据样本数增广至10个,使得样本数满足Bootstrap方法的适用条件;然后再利用Bootstrap方法得到轴用阶梯圈的寿命可靠性评估结果。     

引江济巢工程对改善巢湖水质的数值模拟分析

巢湖受周围城市工业化及农业生产迅速发展的影响,湖区及流域的生态环境发生了巨大变化,尤其是近几年巢湖水质达到重富营养化水平。引江济巢工程是改善巢湖水质的重要工程措施,采用EFDC生态动力学模型模拟了巢湖不同调水流量、调水线路、调水时间对水环境的影响。结果表明,引江济巢工程在一定程度、时间上使巢湖湖区水质发生一定程度的改善,但若入湖水质不达标,调水也增加了巢湖的富营养化风险。     

Adomian decomposition method for the MHD flow of a viscous fluid with the influence of dissipative heat energy

An investigation is carried out on the effect of dissipative heat energy on the flow of an electrically conducting viscous fluid past a shrinking sheet. Both viscous and Joule dissipation effects are considered along with heat generation/absorption for the enhancement of heat transfer properties. The governing nonlinear coupled partial differential equations are transformed into nonlinear ordinary differential equations by a suitable choice of similarity transformations. However, the complex transformed equations are solved by an approximate analytical method known as the Adomian decomposition method with a suitable initial guess solution assumed from the known initial conditions. Moreover, the behavior of several parameters characterizing the flow phenomena are studied via graphs and the numerical computations for the engineering coefficients are obtained and presented through tables. However, the major outcomes of the results are that a higher suction is required to resist the fluid temperature and sinks as well as the dissipative heat energy favors enhancing the fluid temperature at all points in the flow domain.     

Modification of pool boiling regimes by sand deposition

Sand spots, attached to a copper ball surface by means of polyvinyl acetate adhesive and distributed over the surface with areal density that ranges between one spot per 1.18 cm² (for low‐density spots) and one spot per 0.51 cm² (for high‐density spots), serve as a temporary heat transfer enhancer during the quenching in liquid nitrogen. Highest heat flux densities, achieved during quenching, lie in the range 10.8 to 20.2 W/cm², depending on the sand layer structure. Application of the temporary enhancer increases an amount of heat, evacuated by highly effective nucleate and transition boiling, by factor of 4.5 as compared with the bare sample. The process of sand layer preparation, data acquisition peculiarities, relationship between heat exchange efficiency and the spots areal density, along with sand grit size are discussed in this paper.     

Short communication: In vitro rumen gas production and starch degradation of starch-based feeds depend on mean particle size

Our objective was to model the effect of mean particle size (mPS) on in vitro rumen starch degradation (IVSD) and the kinetics of gas production for different starch-based feeds. For each feed, 2 batches of the same grains were separately processed through 2 different mills (cutter or rotor speed mills), with or without different screens to achieve a wide range of mPS (0.32 to 3.31 mm for corn meals; 0.19 to 2.81 mm for barley meals; 0.16 to 2.13 mm for wheat meals; 0.28 to 2.32 mm for oat meals; 0.21 to 2.36 mm for rye meals; 0.40 to 1.79 for sorghum meals; 0.26 to 4.71 mm for pea meals; and 0.25 to 4.53 mm for faba meals). The IVSD data and gas production kinetics, obtained by fitting to a single-pool exponential model, were analyzed using a completely randomized design, in which the main tested effect was mPS (n = 6 for all tested meals, except n = 7 for corn meals and n = 5 for sorghum meals). Rumen inocula were collected from 2 fistulated Holstein dairy cows that were fed a total mixed ration consisting of 16.2% crude protein, 28.5% starch, and 35.0% neutral detergent fiber on a dry matter basis. The IVSD, evaluated after 7 h of rumen incubation, decreased linearly with increasing mPS for corn, barley, wheat, rye, pea, and faba meals, and decreased quadratically with increasing mPS for the other meals. The y-axis intercept for 7-h IVSD was below 90% starch for corn, barley, and rye feeds and greater than 90% for the other tested feeds. The mPS adjustment factors for the rate of rumen starch degradation varied widely among the different tested feeds. We found a linear decrease in starch degradation with increasing mPS for barley, wheat, rye, and pea meals, whereas we noted a quadratic decrease in starch degradation for the other tested meals. Further, we observed a linear decrease in the rate of gas production with increasing mPS in each tested feed, except for pea meal, which had a quadratic relationship. For each 1 mm increase in mPS, the gas production was adjusted by ?0.009 h^?1 for corn, ?0.011 h^?1 for barley, ?0.008 h^?1 for wheat, and ?0.006 h^?1 for faba, whereas numerically greater adjustments were needed for oat (?0.022 h^?1), rye (?0.017 h^?1), and sorghum (?0.014 h^?1). These mPS adjustment factors could be used to modify the starch-based feed energy values as a function of mean particle size, although in vivo validation is required.     

Enhanced oil recovery from carbonate reservoirs by spontaneous imbibition of low salinity water

An experimental study was performed to investigate the impact of low salinity water on wettability alteration in carbonate core samples from southern Iranian reservoirs by spontaneous imbibition. In this paper, the effect of temperature, salinity, permeability and connate water were investigated by comparing the produced hydrocarbon curves. Contact angle measurements were taken to confirm the alteration of surface wettability of porous media. Oil recovery was enhanced by increasing the dilution ratio of sea water, and there existed an optimum dilution ratio at which the highest oil recovery was achieved. In addition, temperature had a very significant impact on oil recovery from carbonate rocks. Furthermore, oil recovery from a spontaneous imbibition process was directly proportional to the permeability of the core samples. The presence of connate water saturation inside the porous media facilitated oil production significantly. Also, the oil recovery from porous media was highly dependent on ion repulsion/attraction activity of the rock surface which directly impacts on the wettability conditions. Finally, the highest ion attraction percentage was measured for sodium while there was no significant change in pH for all experiments.     

Reduced basis method for managed pressure drilling based on a model with local nonlinearities

To circumvent restrictions of conventional drilling methods, such as slow control actions and inability to drill depleted reservoirs, a drilling method called managed pressure drilling (MPD) has been developed. In MPD, single-phase flow processes can be modeled as a feedback interconnection of a high-order linear system and a low-order nonlinear system. These nonlinearities appear locally both inside and at the boundaries of the computational domain. To obtain a fast simulation platform for real-time purposes (eg, online model-based controller implementation), model order reduction is required for MPD. However, the local nonlinearities render applying model order reduction techniques challenging. In this study, a new approach is proposed to deal with such nonlinearities within the reduced basis (RB) context and it is successfully tested on a model for MPD. Contrary to the classical RB technique, the proposed approach not only does not generate nonphysical spikes at the locations of these local nonlinearities but also yields high speedup factors. The obtained reduced-order model can be used for efficient online simulation and controller design for drilling systems with MPD.     

闭口闪点测定方法的对比分析

对我国常用的闭口闪点测定方法宾斯基-马丁闭口杯法、阿贝尔闭口杯法和泰格闭口杯法的测定原理进行对比分析，并采用这3种方法分别对2种有证标准样品、4种有机试剂样品和7种喷气燃料样品的闭口闪点进行测定。结果表明：这3种方法在适用范围、仪器结构、升温速率和点火操作要求等方面都有一定差异，导致采用这3种方法测定同一样品的闭口闪点结果略有差异，闪点测定结果之间的最大差值与样品闪点的高低呈正相关；与阿贝尔闭口杯法相比，宾斯基-马丁闭口杯法测得的闪点结果较高，对于3号喷气燃料，二者之差为0～1.0 ℃，阿贝尔闭口杯法更适合3号喷气燃料闭口闪点的测定；对于纯有机试剂样品，阿贝尔闭口杯法和宾斯基-马丁闭口杯法测得的闪点结果呈现较好的线性关系。     

不同煤层掘进工作面瞬变电磁法探测应用研究

煤矿井下瞬变电磁法成为煤矿井下超前探测工作的重要手段，在矿井水害预测预报上发挥着很大的作用。随着矿井上组煤层资源的逐渐枯竭，煤矿开采资源逐渐延伸向下组煤层。同一井田范围内同煤层及其顶底板的岩性特征一般相差不大，瞬变电磁法在同煤层施工过程中接收到的物理背景场较为接近；而不同煤层及其顶底板岩性特征通常会有较大的差别，瞬变电磁法在不同煤层施工过程中会接收到差别较大的物理背景场。当矿井存在多煤层开采时，通过大量数据研究瞬变电磁法在不同煤层巷道探测中的响应特征规律，分析并掌握不同煤层条件对瞬变电磁法探测结果的影响，能够提高瞬变电磁法在多煤层探测成果的准确性。